Ricoh SMB scan hitelesítési hiba

Open a telnet connection to the copier and do the following that is in BOLD. This may fix the issue without effecting the scanning from other machines. If it does not work run the same again but make the “1” a “0” and the “445” a “139” and it will be back to default. Cycle the power after word. Be sure to tap “logout” after changing the settings and typing “yes” at the end to save the settings after logout.

msh> smb client auth

-Displays the current setting

msh> smb client auth 1

-Enables NTLMv2

msh> logout

-Saves data

Setting value Result

0 (default) SMB client uses NTLM/LM authentication.

1 SMB client uses NTLMv2/NTLM/LM authentication.

Authentication level setting: The device will use only one protocol with the priority that is the highest among the available protocols. The priorities are listed in the table below. The device cannot switch between them automatically.

Priority Authentication

Level 0 (default) Level 1

High

|

Low NTLMv1 NTLMv2

LAN Manager NTLMv1

Plain Text LAN Manager

N/A Plain Text

The SMB port can be changed via Telnet:

msh> smb client port

-Displays the current setting

msh> smb client port 445

-Change port number

Setting value Result

139 (default) SMB client uses port 139 port

445 SMB client uses port 445 port